Automatic Backwash Self Cleaning Filter for Waste Water Treatment Filter

When water runs through the water inlet into the filter element, the impurities were intercepted on the inner wall of the filter
element, and the clean water flows out of the outlet. As the impurities in the inner surface of the filter tube piles up, the
differential pressure between the inlet and outlet runs up to the preset value, the self-cleaning process will begin. The
self-cleaning process can also begin when it reaches the washing time or manual prefabrication.
And it includes two steps: Open the automatic drain valve on the filter; the cleaning brush inside the filter mesh is driven by
the motor, and the impurities stopped by the filter mesh will be discharged from the drain valve.
When cleaning, the system does not cut off; the whole operation process of the filter is controlled by an intelligent control box
which is equipped with the filter.
Control mode consists of differential pressure, time and manual control.

Product Name	Self cleaning filter
Applicable liquid	Water and viscous liquids(˂800,000cps)
Filter precision	10-5,000μm
Design temperature	0-200°C(It depends on seals.)
Single filtering area	0.14m2-1.45m2
Cleaning Pressure Drop	0.05MPa
Connection Standard	Flange(HG20592-2009)
Filter elements	V-shaped wadge net/ sintered mesh
Filter element material	SS304/SS316L/Duplex 2205
Housing material	SS304/SS316L/Carbon Steel/Duplex 2205
Brush material	SS304/SS316L/Duplex 2205
Housing seal material	NBR Nitrile Rubber(Standard)/viton (FKM) fluoro rubber
Discharging valve	Electric ball valve, protective grade IP65
Facility supply	380V 3 phase 50Hz